品牌： 3M

货号： 1469SB

规格：3 mL

产品订购请点击此处

3M Vetbond Tissue Adhesive 组织胶水 （PN: 1469SB)

3M组织胶水(Vetbond)是一种氰基丙烯酸正丁酯粘合剂，在兽医中可用来粘合组织、保护伤口，而常常不再需要缝线和绷带。3M组织胶水同时也是止血剂，蓝色液滴使得更容易观察涂覆情况，方便可挤压塑料小瓶包装，极尖细的瓶口易于产生小的液滴。
Item Description:
3M™ Vetbond™ Tissue Adhesive is an n-butyl cyanoacrylate adhesive used to bond tissue together for veterinary procedures (i.e. cat declaws, lacerations, abrasions, suture/staple line sealing, tooth extractions, oral surgeries, and dewclaw removal). Product contains blue dye to allow user to easily see where product has been applied. On contact with body tissue, Vetbond adhesive changes from liquid to solid state by polymerizing within seconds to seal a wound. Adhesive stops minor bleeding and binds wound edges. May eliminate need for sutures/bandages in some instances. Also acts as a barrier to keep foreign matter from entering the wound. Tissue adhesive is sloughed as healing occurs. Each 3 ml bottle contains approximately 150 drops.
Additional Information

• 1, Reduces tissue trauma and need for analgesia in minor wound repair.     

• 2, Excellent for quick, minor wound repairs.     

• 3, Acts as a physical barrier to keep foreign matters from entering wound.    

Recommended uses:

• 1, Low tension minor wounds   

• 2, Lacerations   

• 3, Abrasions   

• 4, Foot pad injuries   

• 5, Oral trauma   

• 6, Small surgical incisions   

• 7, Oral surgery   

• 8, Tooth extraction   

• 9, Dew claw removal     

 FeaturesBenefitsConvenientBlue indicatorEasy visualization.AdhesiveMinimizes tissue trauma. Reduces need for anesthesiaTime savingBonds tissue together in 15secsAvoids the need for time consuming suturing and suture removalEconomicalBottle contains 150 dropsSufficient for 50-75 small wound closuresVersatileHaemostatic agentParticular benefit after removal of warts, polyps or teethSupportiveUse between tension sutures or other tension devicesGive support to reduce the incidence of dehiscence Contra-indications  .

*Do not use Vetbond tissue adhesive on: 

• 1, Infected wounds   

• 2, Deep puncture wounds   

• 3, High tension wounds (unless as a support to sutures)    

• 4, Although Vetbond tissue adhesive is a haemostatic agent, it is not designed to stop the flow from large vessels.

 Precautions
1. Avoid Contact With Skin And Eyes. For Use Near Eyes, Place Damp Towel Over Eyes For Protection. if On Skin, Wipe Immediately With A Paper Towel. May Be Removed From Skin With Dimethylsulfoxide (dmso). if In Eyes, Hold Eyelids Open And Flush Thoroughly With Water. An Opththalmologist Should Be Consulted.
2. Use In Well-ventilated Are. Avoid Breathing Vapors Over Long Periods Of Time.
3. Avoid Contact Of Adhesive With Instruments, Gloves And Surgical Instruments. Polymerized Adhesive On Instruments Can Be Removed By Soaking In Acetone.
4. Do Not Use If Adhesive Appears Thicker Than Water At Room Temperature. Thickened Product Has Partially Polymerized And Will Not Form An Acceptable Bond.
5. Do Not Use Internally, On Infected And/or Deep Puncture Wounds, Or Below The Epidermal Layer.
6. Do Not Use In The Presence Of Soaps, Cotton Products (gauze, Cotton Tipped Applicators, Etc.), Basic Substances (soaps, Etc.) Or Polyurethane Foam Applicators. These Materials May Cause Excessive Exothermic (heat Generating) Reaction.
Storage
1. Product can be refrigerated or frozen to extend shelf life before opening.
2. Store bottle upright on shelf in a cool、dry place (away from heat). After opening, DO NOT RETURN BOTTLE TO REFRIGERATOR.
Note
A white chalky material may form on the outside of the bottle (bottle blooming). This is normal and does not compromise the effectiveness or the integrity of Vetbond tissue adhesive.
Instructions
1. Vetbond tissue adhesive must be at room temperature before use. Do not heat.
2. Remove bottle cap. To open, cut off bottle tip with scissors or blade. Place flexible applicator tip on bottle.
3. Vetbond adhesive may be used between stainless steel staples, but application of adhesive on staples may interfere with staple removal.
4. When finished, remove excess adhesive in vial tip by holding bottle upright and gently squeeze single drop of adhesive out of tip onto a paper towel. Wipe bottle tip with the same paper towel. Replace bottle cap. Expel adhesive from applicator tip by pushing air through it from a standard syringe.
Wound/surgical Application
1. Clip hair from site.
2. Wash with anti-bacterial soap, rinse and dry.
3. Apply preoperative prep (3M™ DuraPrep™ Surgical Solution, povidone-iodine preparations, chlorhexidine or isopropyl alcohol).
4. Allow the prep solution to completely dry prior to surgery.
5. After the surgical procedure is complete, approximate the edges of the wound/surgical incision.
6. Application site should be free of excess fluids for best adhesion and to avoid an excessive exothermic (heat generating) reaction.
7. Apply Vetbound adhesive sparingly to the surface of the site to form a thin layer. Thick applications will crack and lift prematurely.
8. Avoid touching moist surfaces with applicator tip.
9. Do not apply Vetbound tissue adhesive internally or below the epidermal layer.
Declaw Application
1. Prepare Surgical Site As Usual And Amputate Claws Using Routine Surgical Procedure.
2. Remove As Much Blood As Possible From Incision Site By Blotting.
3. Approximate The Edges Of The Wound/surgical Site And Sparingly Apply Vetbond Tissue Adhesive To Cut Surfaces Of The Skin Using The Plastic Applicator Tip Provided. One Drop For Each Digit Should Be Sufficient. caution
*Do not allow Vetbond tissue adhesive to drip into the cavity. Any residual tissue adhesive below the closure site can cause foreign body reactions. Do not glue hair into site.
4. Hold skin edges for 5-10 seconds.
5. After completing the procedure, check for bleeding and reapply a drop of adhesive to the skin edges if necessary. Bleeding will normally stop within 5-10 minutes. Sutures or dressings are usually not needed, but a pressure bandage may be applied if warranted.